conditioning reaper TP-SA 2001 Full

The conditioning harvester TP-SA 2001 Full allow to cut today and to pack tomorrow. The unique system of blades of rectilinear movement that cuts without damaging the pasture, avoiding the development of diseases.

Our machine prepares the forage, shorting the drying action it lower the risk of rains. Thanks to two fluted rubber rollers that work on the wide one of the row. The conditioning works squashing the stems and breaking each at 7 cm., at the same time it eliminates by the rubb the wax layer that covers the vegetable. This triple action produces the fast dehydration of the plants, obtaining the drying in half of the time.

Why we make a machine that´s cut at sections and not with discs as the others?
The diference of growing of a week is between the alfalfa cut with a machine like ours and other with the sistems of cutting with disc leaving the a bad cut in the steams.

With only four cuts in those conditions, you would lose one month of growing. So in spring you will lost the equivalent of about 10,000 kgs of fresh grass for hectare.

Also it is necessary to consider the lost of alfalfa plants by the diseases that penetrate by the shrill wounds of the bad cuts done.

Operative cost: a single tractor is necessary, not more than 60 HP. Is nothing comparativily with other harvesters that must be operated with tractors of 100/120 HP the user saves several liters of gasoline.
In addition the replacement is very small compare to the benefit that this machine generate. Costo de Inversión: sensiblemente menor.

Other advantages for choosing our harvester...

Constant height of cut: thanks to the floating platform with limitor skids.

Strait cuts: By the optimal operation of the Box of blades in rectilinear movements of frictions, and the efficiency of the cut by sections (like scissors cut). The permanent sharpened of ¨puntones¨.

Uniformity in the drying: The conditioning allows a drying of stems and leaves unifom.

Reduction of the drying: Normally it is reduced to 1 and 3 days.

 

Technical Features:

Total wide:
Traveling position: 3,80 mts.
Work Position: 4,43 mts.
Wide of cut: 2,70 mts

Ability to work: You will have 2,5 has. per hour at 9 Km/h of speed in tractor with not more than 60 HP

Height: Traveling position 1.19 mts. - Work position: 1,06 mts. - Power suply 520/560 RPM

Wide of row: Infinite positions between 0.60 and 2.70 mts. by adjustable covers.

Windlass of retráctiles prongs of wire 5.50 mm

Bar of cuts: Blade with riveted sections 206236M1 of low maintenance.
Box of blade with rectilinear movement without losing power.
Revolutions of box blade 780 RPM.

Conditioning: Helical conditioning rubber
Rollers with gear.
Work between the total of the wide of cut (2.70 mts.).
Regulation of pressure between rollers by torsion bars.
Diameter of the roller 260 mm.